photo printed on printer copy paperin black and white or color and sized to fit on wood slice
Mod Podgematte finish
decorative ribbon
Instructions
Working one ornament at a time, place a wood slice over top of the photo and trace along the outer edge.
photo printed on printer copy paper
Using a pair of scissors, cut along the pencil line.
Position the cut out photo on top of the wood slice to ensure it fits. If too big, trim off the edges a bit.
Brush on a layer of mod podge over the wood slice.
wood slice, Mod Podge
With the back side of the photo facing up, brush on a layer of mod podge on the back side of the cut out photo.
Press the photo on to the wood slice and press gently with fingers. You can also use a craft stick to help press the photo in place.
Apply a thin layer of Mod Podge over top of the photo and leave it to dry fully before assembling the ornaments.
Insert the screw eye to the top of the wood slice. If needed, use a drill with a similar sized drill bit to make a pilot hole.
Cut three pieces of ribbon 10” long.
decorative ribbon
Insert the end of the ribbon through the screw eye and tie ends together.
Of course, if you purchase wood slices that already have the eye hook or a hole drilled in them, you can skip this step.
Notes
If you'd like to add something other than a photo to the opposite side of the ornament, check out my Wood Slice Christmas Ornaments with free SVG files you can use with your Cricut Joy.